Appreciate the reply!

How much for the 10/22 shorty barrel, bolt & charging handle??

Interesting, I’ll have to look into the foot sanding deal, hadn’t heard of that.

I’ll also try out the .16 layer lines and see if that helps on the supports.

Thanks for the tips.

Few more pics of this lower. Overall I’m very impressed with how it came out for my first 2A print, even with the roughness on where the supports were.

I started working on them this evening a little by sanding with some mini files lightly. I think going slow and easy with the files and then some light finish sanding with sandpaper will clean them up pretty well.

Any advice on tweaks I could make to correct it? And yea I’ve been cautious to not mess with any of the orientation on the plate. Read early on in my research to generally not change the plate setups if at all possible.

I’ll definitely look into that!

Noted, thanks for the heads up.

I’ll post a pic of the top and sides cus I feel they turned out really good for my first go. Was just a bit put off by the undersides and support surfaces. These will just be range toys and to have fun projects to work with. Nothing serious enough for a professional print. That’s cool though, didn’t know you could do such a thing.

Yea I’m still not sure. I gotta clean some of it up as it still has little bits of supports stuck in places. This pic was after just popping all the supports off.

Thanks for the rec’s. Tried them both today. I think I prefer Thunder so far..