11
So what’s my best bet on cleaning this up?
(forum.guncadindex.com)
Hey guys, I’ve just completed my first prints. The top surfaces and sides came out really good, but the undersides came out a little rough. Especially where supports were, what’s the accepted standards for cleaning these areas up? Sandpaper, files, dremel?
What settings should I be looking at to make my next prints even better in these areas?
My setup: Qidi xplus3 Sunlu PLA + 2.0 (using its default filament profile in orca) @ 230/60 300blkfde’s orca/machine settings. 12 walls, 80% infill. Layer height: .2 Support distances: .19
I appreciate the feedback!
That looks pretty good!
If you decide to sand it, don’t do it too much and wear a mask. The particles that result from that sanding aren’t great.
There are some acetone based approaches too.
Personally I just don’t try to clean it up more than that, and if you really need the part to be pristinely clean, I prototype myself and then buy a final print from a professional 3D printing company.
Acetone doesn't work for PLA
Noted, thanks for the heads up.