11
So what’s my best bet on cleaning this up?
(forum.guncadindex.com)
Hey guys, I’ve just completed my first prints. The top surfaces and sides came out really good, but the undersides came out a little rough. Especially where supports were, what’s the accepted standards for cleaning these areas up? Sandpaper, files, dremel?
What settings should I be looking at to make my next prints even better in these areas?
My setup: Qidi xplus3 Sunlu PLA + 2.0 (using its default filament profile in orca) @ 230/60 300blkfde’s orca/machine settings. 12 walls, 80% infill. Layer height: .2 Support distances: .19
I appreciate the feedback!
I’ll post a pic of the top and sides cus I feel they turned out really good for my first go. Was just a bit put off by the undersides and support surfaces. These will just be range toys and to have fun projects to work with. Nothing serious enough for a professional print. That’s cool though, didn’t know you could do such a thing.