11
So what’s my best bet on cleaning this up?
(forum.guncadindex.com)
Hey guys, I’ve just completed my first prints. The top surfaces and sides came out really good, but the undersides came out a little rough. Especially where supports were, what’s the accepted standards for cleaning these areas up? Sandpaper, files, dremel?
What settings should I be looking at to make my next prints even better in these areas?
My setup: Qidi xplus3 Sunlu PLA + 2.0 (using its default filament profile in orca) @ 230/60 300blkfde’s orca/machine settings. 12 walls, 80% infill. Layer height: .2 Support distances: .19
I appreciate the feedback!
There are prints you can use to calibrate the support interface distance and it's specific to your layer height. They are available in bambu software but I imagine you can use them in orca slicer for your specific printer. You can select each tower with a different distance. It's not a long print.
I’ll definitely look into that!