[-] KaninchenSpeed 6 points 3 days ago* (last edited 3 days ago)

You have to check the cameras manual, if it says passive poe and a voltage, then one of these injectors with the correct voltage will work, if it doesn't then you need a active poe injector with at least the required power (af < at < bt).

[-] KaninchenSpeed 48 points 1 week ago

Oder wenn Polizisten Datenabfragen aus privaten gründen machen

[-] KaninchenSpeed 2 points 2 weeks ago* (last edited 2 weeks ago)

Im doing this with esphome, i replaced the thermostats with dht22 sensors and wired the valves via solid state relays (one for each zone) to the esp. Im using an esp with ethernet (wt32-eth01 clone), but wifi can work, if you can place it outside of the metal box of the heating system.

For control you can use a pid controller. I think there are some, which can run directly on the esp if everything is connected to the same esp.

Note: Dont use dht22 in the bathroom, it will slowly get less accurate when exposed to high humidity. Running the onewire of the sensors straight through existing 5 conductor thermostat wire/1.5mm^2 wire works reliably

KaninchenSpeed

joined 2 weeks ago