74
Why still using the imperial system?
(abananaforscale.com)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 31 Mar 2024
74 points (100.0% liked)
Memes
45550 readers
1714 users here now
Rules:
- Be civil and nice.
- Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.
founded 5 years ago
MODERATORS
Well I'm building a table right now, and it was pretty easy to choose a size for a mortise and tenon in my 3/4" stock, a third of 3/4" is 1/4". If I wanted half its width, that's 3/8". Mental math is a lot easier than "What's a third of 19mm." In the wood shop, I rarely have to divide things by five or ten. I have to divide things by two, three and four a lot.
I don't know anything about carpentry, so I'll take your word on it.
My best guess is that the standards are different. For example 2cm stock instead of 1.9. Then only the 1/3 is problematic.
I'm building a shaker table out of white oak. I milled all my stock to 3/4" thickness.
Just today, I resawed a board to 3/8", or half its original thickness. I glued two boards together to make 3/2" (1 1/2") thick table legs, and I cut mortises 1/3 the thickness of the stock, or a nice even 1/4".
I'm familiar with the metric system, I learned chemistry and physics in metric. I prefer woodworking in fractional inches because metric seems like a bigger pain in the ass