119
Why btrfs gets huge perf hit with background IO work?
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 10 Nov 2023
119 points (100.0% liked)
Linux
48340 readers
333 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
@Max_P @yote_zip
A file system and a raid setup all in one with facebook's code for de-/compression ... yet another piece of software that tries to do the work for several others.
ext4 will rarely have extreme loads unless all you do is backup and mirroring. For more accurate data read/write and better checks use xfs and external journaling. On M2 it is by far the fastest solution and far more secure than ext.
@Max_P @yote_zip
On magnetic disk there is physical location for each bit of data written, for ssd it is all virtual space handled by internal software simulating a magnetic drive. The variation from disk to disk is much higher than the sensitivity of the fs.
You want accuracy and reliability of data storage, use HDD and Raid!
RAID doesn't checksum and heal the rotten data. It's game over before you even have a filesystem on top of it, because said filesystem can't directly access the underlying disks because of the RAID layer.
Errors will occur, and RAID has no way of handling it. You have a RAID1, disk 1 says it's a 0, disk 2 says it's a 1. Who's right? RAID can't tell, btrfs and ZFS can. RAID won't even notice there's a couple flipped bits, it'll just pass them along. ZFS will just retry the read on both disks, pick the block that matches the checksum, and write the correct data back on the other disk. That's why people with lots of data loves ZFS and RAIDZ.
The solution isn't more reliable hardware, the solution software that can tell you and recover from your failing hardware.