How do you all keep your z home consistent? (lemmy.world)

submitted 1 year ago by IMALlama@lemmy.world to c/vorondesign@lemmy.world

7 comments fedilink hide all child comments

Title basically.

Obviously, cold nozzle + filament on it from my last print = the printer thinks the nozzle is lower than it actually is.

Preheating the nozzle helps some, but if I want true consistency I need to mechanically whipe the nozzle/grab the bit of plastic that oozes out with a pair of needle nose pliers.

I know nozzle brush mods are a thing, but aren't the hard on your nozzle? Does anyone have any alternative ideas?

you are viewing a single comment's thread
view the rest of the comments

[-] Dangerhart@lemm.ee 2 points 1 year ago

Sorry I just realized the way I described everything was actually pretty confusing. After every print I run a clean macro that moves the nozzle up front and heats to 230 and sits there. After about 10 minutes I wipe it then have a clean complete macro to cool down and move it back to the center. Then I start a print and the homing etc is all done at a lower temp, I can't remember if it's static or nozzle temp -75c or something

this post was submitted on 16 Sep 2023

7 points (100.0% liked)

VoronDesign

301 readers

1 users here now

lemmy.world community for VoronDesign 3D printers

founded 1 year ago

MODERATORS

Haribro@lemmy.world