overview for ItsBildo

FOSSCADToo Mods by ItsBildo in c/general@forum.guncadindex.com

[-] ItsBildo@forum.guncadindex.com 4 points 1 week ago

Would you happen to have a link to your post?

PA6-CF vs PA6-GF - Impact Toughness vs Brittleness by ItsBildo in c/general@forum.guncadindex.com

[-] ItsBildo@forum.guncadindex.com 1 points 1 month ago

From all the research I've done, they're quite similar, however PA6-CF is the superior material

2

PPA-CF vs PA6-CF? (forum.guncadindex.com)

submitted 2 months ago by ItsBildo@forum.guncadindex.com to c/general@forum.guncadindex.com

4 comments fedilink

PPA-CF vs PA6-CF?

Does anyone have experience printing PPA-CF and PA6-CF? I had read that "PPA-CF is 48% stronger" than PA6 if you get good layer adhesion, but I'm seeing conflicting info regarding impact resistance. Anyone have input who's printed and used both?

Help me choose a printer | X1C vs P1S | What's your preferred filament? by ItsBildo in c/general@forum.guncadindex.com

[-] ItsBildo@forum.guncadindex.com 1 points 2 months ago* (last edited 2 months ago)

Elegoo Centauri Carbon, it's half the price of p1s, can print nylon out of the box as it comes with a hardened hotend, and has an enclosure for $299.99

Whatever you say, Boomer by ItsBildo in c/general@forum.guncadindex.com

[-] ItsBildo@forum.guncadindex.com 1 points 2 months ago

PA6-CF reprint

2

Whatever you say, Boomer (forum.guncadindex.com)

submitted 2 months ago by ItsBildo@forum.guncadindex.com to c/general@forum.guncadindex.com

2 comments fedilink

Kaewon's OK Boomer checkered remix. Polymaker PLA-Tough FDE

1

Refugees of r/FOSSCAD, lend me thy ears! (forum.guncadindex.com)

submitted 2 months ago by ItsBildo@forum.guncadindex.com to c/general@forum.guncadindex.com

0 comments fedilink

This just may be the solution to our woes. Big shout out to shittinator for getting this setup.
Can't Stop the signal!