20
PWC - 9mm and 5.7 - Q&A
(forum.guncadindex.com)
(slightly older beta versions in the picture)
Hey all!
Because the "PWC: DLC" (DownLoadable Content, for you boomers and non-gamers) will be releasing soon, I figured I'd make a post and open up a general Q&A about the PWC.
Questions are not limited to the DLC, 9mm, or 5.7 - all questions about the PWC are welcome!
i mean, it's right there in the name, sten designs have used the upper hole, the lower reinforcement plate, and the side cutout - there's versions for each design
the pwc 9 relies on the lower only
perfect... i will print out the 15rd magazine labeled..
Lower Catch Printed
whats the difference between:
RR Feed Lips - Lower Catch
Printed - Lower Catch
I loaded each into 15rd varient into the slicer.. both look the same. Also.. which one should be used for the PWC-9 ?
RR is riptide rails reinforcement lips
yeah... i figured that out the other day. thanks for the confirmation though.