Started with an Ender5. Mostly stock, but got a cheap direct drive bracket, and put a metal throat in the heatbreak to make it an all metal hotend.

Then I got a Sainsmart coreception because I liked the frame of the ender5, but the concept of Corexy just seemed better, and looking back, it definitely is.

Then I got 3 more Creativity Elf printers, which are basically the same as the Coreception.

Then I got a Voron. I want a bigger bed. I really wanted to go with RatRig as they have a kit with 500mm. But I just didn't feel comfortable with how much smaller the community behind it was and the documentation just didn't seem as good as the Voron. This kit was from Formbot. The wiring sucked. After 1000 hours, wires literally just came apart inside the cable chains. One after another. I could print for more than a few days without another wire breaking. All in different places too. I moved all the wires out the chains, and it's been solid since.

And just this last week or 2, I got another Voron. This time from Magic Phoenix. And I am documenting the process on my blog.

https://automatedhome.party/2023/06/27/my-secondmagic-phoenix-voron-2-4-3d-printer-vs-my-first-voronformbot/

I just finished it up a couple days ago. It has been awesome. The details are there in my blog post, but I'm definitely going to be buying from them again. This project(when including all the stuff I add to my printers like cameras and stuff) cost $350 less than the formbot kit. And it has a LOT of quality of life improvements over a standard Voron kit. Tap, StealthBurner and CANBUS are a few. Highly recommended.