Nice not bad! A pretty easy upgrade for power (if you have a mainboard that supports it) is to go to 48v for the steppers with 5160 step sticks, gobs more power, but you are also now getting to territory where a crash can start really breaking stuff. There is also a group in the discord where they are working on the AWD mod to add 2 more steppers to the XY motion allowing for insane speeds.

North of ~25mm^3 I've found I need to really up the temps to keep up with PLA (mainly using eSun) which then also means a lot more cooling. I managed a pretty decent 14 minute benchy but need to retest as I've upgraded my cooling.

My current setup for extrusion:

• Rapido high flow with CHT
• Orbiter 2 with blowy mod to run at higher current
• CPAP remote cooling with a WS7040 blower
• HUVUD toolboard on printhead

On my VC3 500 I use a rapido with a 0.4mm. My default PLA settings are 300mms with 10kmms2 acceleration. I'm not sure about OP but for me the larger build volume lets me kick off a full plate of parts and come back a few hours later. Gets pretty good quality but at that size/weight you do get some ringing on the parts.