SF5 updates / remixes? by Dwalk51 in c/general@forum.guncadindex.com
[-] Dwalk51@fosscad.io 1 points 3 weeks ago

Yep, like it’s too close to the wall. I’ve even tried over sizing the hole and then using a metal liner to hold it perfectly even to no avail.

SF5 updates / remixes? by Dwalk51 in c/general@forum.guncadindex.com
[-] Dwalk51@fosscad.io 2 points 3 weeks ago

Amazing, thanks for the recommendations. That monolithic lower looks interesting, I’ll have to look into it more.

7
SF5 updates / remixes? (fosscad.io)
submitted 3 weeks ago* (last edited 3 weeks ago) by Dwalk51@fosscad.io to c/general@forum.guncadindex.com
4 comments fedilink

Since the SF5 was released, have there been any significant updates/changes? I built one a while back but the super safety indent would wobble no matter what. The additional play in the indent would allow the cam to slide to ‘safe’ while firing quickly. I’d like to rebuild it so the SS works reliably.

    1. has anyone else had this problem and have any suggestions to fix it?
    1. have there been any good SF5 alternates/remixes that I could print instead?

I figure if I need to reprint the lower again, might as well see if there are any new designs. -

Dwalk51

joined 2 months ago