Poor people obviously can’t afford a MagSafe charger. Target market is poor people who can’t afford a $1000 phone. Ergo.
But seriously, i suspect that it’s something along those lines. People who hold onto their phone longer and/or buy older model phones may not use MagSafe. Personally, I only use it in the car. I’m not a huge fan of the idea of charging losses, and I’ve had trouble finding chargers that fit my desires (ie desk charger; I don’t own a watch or AirPods).
The RO system is dependent on the membrane. Theres a level of standardization for membranes and pre-filters. This is an example: https://www.freshwatersystems.com/products/axeon-5-stage-ro-system-50-75-gpd Conversely, there’s a lot of branded systems that require special format filters and membranes (https://www.premierh2o.com/ro-pure-plus-voc-system), which can naturally only be sourced from the manufacturer. A good 4-stage system can be sourced for about $200 give or take.
RO was developed to desalinate water. Therefore, if you use a salt-based ion exchange water softener (the standard water softener) and then run that through an RO, it’ll be a pretty straightforward process. The more pressure you can provide up front (within the specs of the system), the more efficient the system will be. (Actually, it’s the pressure differential that really makes a difference, so if you’re pulling out one cup at a time, it’s less efficient than pulling out a litre). If your water is very hard, there will be more brine produced. There are ways to minimize that waste (effectively by injecting it into the hot water supply), if that’s important to you.
A distiller will have the same problems any boiler will have.
I’ve got a softener and a RO. It comes in between 450 and 550ppm and leaves around 30-70ppm. You typically want to see a >90% reduction; less than that and the membrane needs replacing or you may have pressure issues.