submitted 1 year ago by Gordon@lemmy.world to c/3dprinting@lemmy.ml

4 comments fedilink hide all child comments

Hey all, so this is the biggest thing I've tried to print. I'm using PETG. I'm getting a lot of repetitive bands of underextrusion that seem to stack up and get worse as the print progresses.

What do you think is causing this? Is this just an inherent thing in the way an Ender 3 works by moving the bed?

top 4 comments

sorted by: hot top controversial new old

[-] squaresinger@feddit.de 1 points 1 year ago

The typical guesses in a case like this:

Bed leveling
Crappy extruder that needs to be tightened or better replaced (I can really recommend the TBG Lite, amazing extruder)
Temperature too low
Crappy or wet filament (wet doesn't apply to PLA, but PETG prints super bad when wet)

Or all of the above.

[-] macgyveringIt@lemmy.sdf.org 1 points 1 year ago

I recently had an issue that caused similar issues. Ended up being a bad wheel on the Z axis. Wheel was damaged and the carriage would move up and down as the Z axis traversed causing that stripped pattern.

Good luck!

[-] jelos98@lemmy.world 0 points 1 year ago

I second “not hot enough”. The PETG lists it’s ideal temp as 230 on the reel, but it seems to need closer to 245-250 or I get similar.

[-] jelos98@lemmy.world 1 points 1 year ago

Er, the PETG I have, I mean

this post was submitted on 15 Jun 2023

4 points (100.0% liked)

3D Printing

4341 readers

1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 3 years ago

MODERATORS

3dnudel@lemmy.ml