I built this releaser from PVC pipe that I bought at Lowe's in Ogdensburg, NY, check valves and solenoids that I bought on Ebay, and fence T-bars that I bought at TSC. The controller was an Arduino Nano in the grey box on the side of the releaser. This one was vertical and sat on top of the IBC draining into the port on the top. It worked quite well and didn't cost a lot to build. I can't remember how much it released per dump but it was under 4 L.
Welcome to Maple Engineering
Visit Maple Engineer on YouTube.
This is a community for those who come up with creative ways to make maple syrup. You don't have to be designing and building homemade vacuum or RO systems to participate. Have you done something cool with your buckets and spiles? Tell us! Are you proud of your tubes and buckets? Show us! Have you built your own homemade gravity of pumped vacuum system? Show it off! Do you design, build, or install giant, gleaming, stainless steel maple syrup production systems? Tell us all about it! If you don't make maple syrup but love it on your pancakes of johnnycake and want to ask question, ask away. The people posting here love to talk about making and eating maple syrup.
You may also be interested in:
RULES:
All Lemmy.ca rules apply here.
Everyone (see rule 98) is welcome.
If you've seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.
[Did you actually think there were 98 rules?]
If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.
Don't be a dick. Yes, this is a catch-all rule.
The mod(s) have the final say.