0.2 owners - Bed heat time? (lemmy.world)

submitted 5 months ago by UnH1ng3d@lemmy.world to c/vorondesign@lemmy.world

6 comments fedilink hide all child comments

0.2 owners, could you tell me how long your bed takes to heat from room temperature to 60 and 100°C please 😁

you are viewing a single comment's thread
view the rest of the comments

[-] morbidcactus@lemmy.ca 2 points 5 months ago

For the v2 it's actually in the sample klipper config under heater_bed as comments.

Totally understand, I'm thinking about building a small trident or 0.2 at some point for the same reason, I very rarely use the entire bed area of the 2.4

[-] UnH1ng3d@lemmy.world 1 points 5 months ago

I can see a bit about the solid state relay overheating with too much power, but that's not the bed. Have I missed something or have you possibly misread something yourself 🤪

I don't know how small you are thinking, but if it's V0 size, make sure you've seen the "crucible" on 3dprintersforants, it looks cool 😎

this post was submitted on 30 May 2024

5 points (100.0% liked)

VoronDesign

305 readers

1 users here now

lemmy.world community for VoronDesign 3D printers

founded 1 year ago

MODERATORS

Haribro@lemmy.world