Hello, and thank you in advance.
I'm making a privacy friendly "ring" cam/doorbell following this guide: https://tristam.ie/2023/758/ which has been great, but requires running a micro-usb cable down to the doorbell for power. I'm hoping to improve on this by using the existing doorbell power instead.
The problem is that I'm a DIY electronics noob and I can't create a mental model for how it should all work. The picture I attached is my existing doorbell wiring scheme, which is as simple as it comes. I totally get how this works. Pressing the doorbell completes the circuit and makes the bingbongs. But this will have to change so the new door cam gets power full time. Ideally without the chime bingbonging full time.
In addition to the ESP-32CAM, button, ring lights, etc., I also bought these: https://www.amazon.com/dp/B079FJSYGY which I thought might be needed to complete the circuit?
I measured the voltage after the transformer and it was around 18 volts, but maybe this is AC and I want DC?
Generally I don't know where in "the loop" to put things. Also, all the existing components are very far apart from each other, so I would love a solution that doesn't involve running any new wires through the walls.
Any help is appreciated. Thank you!!
xoJimbabwe
Your drawing is a little confusing. Here's what you need:
There's nothing special about a setup with a light in the button. It's literally just an incandescent bulb across the button. If you connect your circuit across the button terminals, it'll work fine.
The 4 diodes in a loop is a "full bridge rectifier" that gives you DC from AC. The 5V regulator could be something like an LM7805.
The "large capacitor" is to keep power applied while the button is pressed, though you might be better off in that case with some small onboard battery. You just have to make sure that your battery charging circuit doesn't draw too much power.