100
When You Walk Away From The Apprentice For 2 Seconds
(lemmy.sdf.org)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 16 Mar 2024
100 points (100.0% liked)
Machinist
669 readers
1 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 1 year ago
MODERATORS
CNC endmill took too big of a cut and probably ended up flying through the wall at the other end of the shop, or just burned a hole through the floor when it melted.