submitted 9 months ago by Lime66@lemmy.world to c/buildapc@lemmy.world

29 comments fedilink hide all child comments

I finished building my PC recently. when I turn on the monitor when the computer isn't on, there's obviously no signal and I see the bouncing logo, but when the computer is on, it says that there is no signal, and that my monitor is going into standby mode, and the display turns off. my gpu seems to be working fine, and I reseated my ram. What should I do?

you are viewing a single comment's thread
view the rest of the comments

[-] HeyJoe@lemmy.world 1 points 9 months ago

I normally see this if there is an onboard display port. If you're not having any luck using only that port try removing the GPU and try again. Once you do get a display check BIOS for settings revolving around what to use if GPU is detected. Either that or you may really have a bad GPU?

[-] Lime66@lemmy.world 1 points 9 months ago

I have a 7800xt. don't know if that would cause a problem

this post was submitted on 11 Feb 2024

13 points (100.0% liked)

Buildapc

3778 readers

2 users here now

founded 1 year ago

MODERATORS

Lemmenmo@lemmy.world