submitted 9 months ago by Lime66@lemmy.world to c/buildapc@lemmy.world

29 comments fedilink hide all child comments

I finished building my PC recently. when I turn on the monitor when the computer isn't on, there's obviously no signal and I see the bouncing logo, but when the computer is on, it says that there is no signal, and that my monitor is going into standby mode, and the display turns off. my gpu seems to be working fine, and I reseated my ram. What should I do?

you are viewing a single comment's thread
view the rest of the comments

[-] Exulion@lemmy.world 2 points 9 months ago

If you can't hear anything does your motherboard have a display? Did it come with a little speaker? Look in your motherboards manual for the best way to get error signals.

Did you give your computer at least 5 min powered on though?

[-] Lime66@lemmy.world 1 points 9 months ago

No i didn't, but my monitor shuts off every time it's connected to my computer so I can't wait that long

[-] Exulion@lemmy.world 1 points 9 months ago* (last edited 9 months ago)

Your monitor doesn't matter just let the computer run for a few minutes then turn the monitor back on

[-] Lime66@lemmy.world 1 points 9 months ago

Oh that's great, I'll see if it works

[-] Exulion@lemmy.world 1 points 9 months ago

Did that happen to work for you?

[-] Lime66@lemmy.world 1 points 9 months ago

No, still have no display and apparently have no boot device which is weird since I wrote fedora onto my usb drive

[-] Exulion@lemmy.world 1 points 9 months ago

Got a parts list?

[-] Lime66@lemmy.world 2 points 9 months ago

MSI mpg b650 wifi ATX Sapphire pure 7800xt Amd ryzen 7600x 32gb Corsair vengeance ddr5

this post was submitted on 11 Feb 2024

13 points (100.0% liked)

Buildapc

3769 readers

20 users here now

founded 1 year ago

MODERATORS

Lemmenmo@lemmy.world