67

Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then..

You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they're apparently not in the ~/.config/cura folder anymore. Nice.

you are viewing a single comment's thread
view the rest of the comments
[-] bluewing@lemm.ee 5 points 10 months ago

While I have always preferred PrusaSlicer, since I do own a Mk3s+, I used to use Cura also. But it just seemed to get worse with every new update/release until I just quite using it at all. Makes me sad because there were some good things things there I really liked.

this post was submitted on 08 Feb 2024
67 points (100.0% liked)

3DPrinting

15763 readers
80 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS