21
Flat bur grinder changes after cleaning (sh.itjust.works)
submitted 1 year ago by arkh2183@sh.itjust.works to c/coffee@lemmy.world
2 comments fedilink hide all child comments

I disassembled and cleaned my Eureka the other day, my first time doing so, and now what was a “2” grind size is closer to a “4.” In other words, it’s grinding finer overall. I’m guessing something was changed during reassembly? Do I need to recalibrate it or anything? I had notes about grind sizes for different coffees, are these all moot now?

you are viewing a single comment's thread
view the rest of the comments
[-] eceforge@iusearchlinux.fyi 9 points 1 year ago

I believe the calibration for these grinders looks something like

  1. Unplug power
  2. Slowly turn grinder by hand while empty
  3. Slowly adjusting grinder knob until grinding plates just barely touch when spun by hand
  4. Adjust dial facade to indicate this is the new "zero" location

Either way, the term "calibration" + the name of your grinder should get you a fairly specific run down.

It's worth noting that if your grinder wasn't calibrated like this when you got it then your notes will indeed need to be redone. But only once because next time you disassemble for cleaning you start at the known zero point again by going through the simple calibration process.

this post was submitted on 26 Oct 2023
21 points (100.0% liked)

Coffee

8398 readers
53 users here now

☕ - The hot beverage that powers the world!

Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!

Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.

founded 1 year ago
MODERATORS
martijn@lemmy.world
dannoffs@lemmy.sdf.org
Xariphon@kbin.social