1053
Raspberry Pi - Introducing: Raspberry Pi 5
(www.raspberrypi.com)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 28 Sep 2023
1053 points (100.0% liked)
Linux
48008 readers
729 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
I started out the same way and now my desk is cluttered with partially completed projects and devices in various states of taken apart. But for me the fun part is learning something new along the project journey. The microcontrollers were a game changer due to their low cost. I'm not trying to fry them, but hey if I screw up who cares it was a couple bucks anyways.
For circuits I design I've mostly been having them created overseas and I'll solder on the components but I'm really curious about hacking a toaster into a refry oven or whatever their called and soldering surface mount components. Not that I need the small form factor or I'm making enough circuits to warrant trying to save on cost, I'm just curious and want to try haha. Gonna need a bigger desk...
Honestly, get the flux and a hot air station instead, imo. Then again, I prefer being able to have control over where the heat is going instead of reflowing everything at once