Running networking though old asphalt roof (lemmy.zip)

submitted 1 year ago* (last edited 10 months ago) by possiblylinux127@lemmy.zip to c/networking@sh.itjust.works

2 comments fedilink hide all child comments

I am trying to run a network cable for a AP but there is a new angled roof built on a old flat ashalt roof. I may end up drilling though the roof but I am curious if there are any other options to run a physical cable

Edit: Asphalt doesn't really block WiFi so I just put the AP in the attic

you are viewing a single comment's thread
view the rest of the comments

[-] biker_bard@lemmy.world 4 points 1 year ago

Are you drilling through the new roof, old roof, or both? The old roof you can probably go at without too much concern since the new roof is the primary now. Any penetrating through the new roof should include adding an appropriate boot that gets lapped into the shingles or detailed appropriately. Going through both will require a combination of the two approaches.

If there are other routing/mounting options like through a wall you’ll typically want to run it in conduit since most wire isn’t UV stable.

[-] possiblylinux127@lemmy.zip 1 points 1 year ago

I'm trying to avoid drilling though the old roof. It is thick and made of blacktop. It would take a while to drill though and would pose a safety harazard due to low ventilation and heat

this post was submitted on 15 Sep 2023

4 points (100.0% liked)

networking

2811 readers

1 users here now

Community for discussing enterprise networks and the ensuing chaos that comes after inheriting or building one.

founded 1 year ago

MODERATORS

manifex@sh.itjust.works