20

Also got it belted up, but found out afterwards that I used a grease that is controversial on the rails (superlube with syncolor). It's recommended by LDO and Nero3D uses it in his video, but many folks on the Voron Discourse say it's a no-go. I'd rather not risk it, so I'm uninstalling the rails, cleaning/degreasing them, and reapplying some white lithium grease.

you are viewing a single comment's thread
view the rest of the comments
[-] dirtdigger@lemmy.world 2 points 1 year ago

Cool cool. I printed a shim to get the right height, I'll just make it a bit taller. Thanks again

[-] IMALlama@lemmy.world 1 points 1 year ago

If you have the printed parts already you can try installing one now to see how it goes, especially if you have the gantry off right now.

this post was submitted on 22 Aug 2023
20 points (100.0% liked)

VoronDesign

305 readers
1 users here now

lemmy.world community for VoronDesign 3D printers

founded 1 year ago
MODERATORS