133
How do you guys make your coffee?
(lemmy.world)
My perfect coffee:
- fill bottle of the same volume as my press with water.
- pour ~10% of it in the electric kettle, and start it.
- put two (or three) full teaspoons of light roasted fine ground coffee in the press
- the water boiled. pour it into the press.
- put remaining cold water in kettle, start it again.
- shake the press a bit so coffee hydrates and foams. Cover the press.
- grab a coffee paper filter (circle) fold it in "pizza-like" shape 4 times and cut the outer skirt, so the new radius is about 1cm larger than the press filter.
- rest of the water is boiling now, pre-water+coffee mix has no foam. Fill press with water.
- put the paper filter on top, and insert the plunger so that along all the inner circumference, the paper filter is between the press inner wall and the plunger.
- press the coffee very slowly, don't rush it at all. It will take you a solid minute or a bit more.
Now you have crystal, non acidic, and flavorful golden coffee. I usually pour a cup immediately, and put the rest in an all-metal insulated little bottle.
I divide the water in two parts to quickly get rid of the foam under the paper filter. Foam makes the pressing way slower. If you have time, you can immediately boil the whole water volume, but leave the coffee mix covered for 5-10 mins and the foam will be gone by then.
Venus are made in steel instead of alluminium so they work in induction stove tops. But the working principle of them is the same as the moka so in a ceramic both of them would have the same issue.
I think the problem with the valve may be related to using a bigger stove top than the moka; normally, you put the moka in a fire that's smaller than it's base and just wait until water boils. Reading the instructions of the moka it says that when using something that's not gas fire, you should use a medium intensity but they say specifically to use a source of heat that's smaller than the heater part of the pot. However, if you are having issues with that because of the ceramic, I'd recommend to preheat the water near boiling point and use that water for the moka; that way you'll have the coffee made sooner and your stove top won't have the time to turn off and on before the coffee is made.
Also, since we are talking about them: always clean your moka with water and nothing else. Do not use soaps or anything for the inner parts of it, just clean water!
Good point about preheating the water. I might try that if I pick one up.
How annoying are they to clean?
Annoyingly easy. As in you just rinse it in water and use your hand without any soap to clean the rests of the coffee. Just remember to change the rubber ring every year or so.
Those things were made to last a lifetime, if you take basic care of it , like, again, cleaning it with just water, and using low-calcium water to prevent deposits that might end blocking the moka (I use filtered water from a brita jar), it will probably outlast you.
Thanks for all the info, I appreciate it. I’ll probably pick one up soon then. Do you use espresso beans for it? Or regular coffee beans? And how finely do you ground your beans, or do you get pre-ground?
I buy pre-ground. Usually kimbo and lavazza have products for moka pots; espresso coffee is not suited for these. If you want to ground yourself, keep in mind the grain shouldn't be as finely ground as for an espresso machine. Think a middle point between espresso and dripping machines.
I’ll look into those. Thanks again for the info.