504
owo (mander.xyz)
you are viewing a single comment's thread
view the rest of the comments
[-] InputZero@lemmy.world 1 points 9 hours ago* (last edited 9 hours ago)

You get it. Pushing AMPs is just a voltage significantly higher than the voltage required to jump a gap, or short a circuit, ect. Depending on your application. I like to think of it as a water slide, the source is the high end, the circuit is the slid, and the sink is the bottom of the slide and pushing AMPs is attaching a comic book villan's version of a pump big enough to drain all the water from the ocean.

[-] mexicancartel@lemmy.dbzer0.com 2 points 9 hours ago

Nahh the "significantly higher voltage" comes only because your device having some form of protection preventing too much current flow. The most simple device would be a resistor and any change in voltage leads to a change in current. So yes you are pusing amps by changing voltage. Pulling amps is by changing resistance so that volt can push amps easier

this post was submitted on 11 Mar 2026
504 points (100.0% liked)

Science Memes

19458 readers
1721 users here now

Welcome to c/science_memes @ Mander.xyz!

A place for majestic STEMLORD peacocking, as well as memes about the realities of working in a lab.



Rules

  1. Don't throw mud. Behave like an intellectual and remember the human.
  2. Keep it rooted (on topic).
  3. No spam.
  4. Infographics welcome, get schooled.

This is a science community. We use the Dawkins definition of meme.



Research Committee

Other Mander Communities

Science and Research

Biology and Life Sciences

Physical Sciences

Humanities and Social Sciences

Practical and Applied Sciences

Memes

Miscellaneous

founded 3 years ago
MODERATORS