20
PWC - 9mm and 5.7 - Q&A
(forum.guncadindex.com)
(slightly older beta versions in the picture)
Hey all!
Because the "PWC: DLC" (DownLoadable Content, for you boomers and non-gamers) will be releasing soon, I figured I'd make a post and open up a general Q&A about the PWC.
Questions are not limited to the DLC, 9mm, or 5.7 - all questions about the PWC are welcome!
is anyone having to file down the l-brackets ? i cant get them to match up or sit flush in the frame slot. i believe i cleared out the support material from those areas. any other suggestions ? file down brackets ? heat brackets prior to inserting into frame ?
edit.. figured it out..
well? what happened?
just had to clear out material in the bracket slots.. i used a thin enough file to clear out the bracket slots and after that was able to sit the brackets in flush.. now i can run the m4 bolts through each bottom bolt hole pairs.
now i am cutting the smooth rods to size..
i took your advice and purchased some extra long smooth rods and just cut them to size as needed.