20
Gaps in first layer, but not in brim?
(lemmy.world)
Hi all,
The attached photo is my brim (top) and first layer (bottom) after stopping the print. I've noticed that my brims look totally fine, but the first layer of the print itself has gaps between the lines.
How do I go about debugging this? I'm using Orcaslicer with an SV08 Max, and customizations I have during slicing include dropping the nozzle .2mm with the following Machine gcode:
G90 ; Absolute
G21 ; Use metric
M83 ; Use relative distances for extrusion
SET_GCODE_OFFSET Z=-0.2 MOVE=0
And a flow ratio of .96 with this ABS, which I commonly use on the Voron as well.
Thoughts?
maybe it's an essential property of the brim to make sure the print doesn't stick to the brim?