1
Originally posted by u/AlternativeFig348 at 2025-06-30T07:26:34Z
I’m not sure If this is what it’s supposed to look like on certain areas the bed appears to be level. It’s an ender 5 pro I’ve had nothing but issues with attempting to make sure the bed is level, and calibrating everything.
u/AlternativeFig348 · 2025-06-30 15:38:42 UTC · score 1
I double checked flow rate right before the print and it was extruding the proper amount. The print started out decent and then just turned to shit once it got to that point. I’m gonna pull the whole hot end apart tonight and clean it and re assemble it, slice with orca and see what happens
u/VtSigma · 2025-06-30 22:51:43 UTC · score 1
I’d make sure your z rods are clean, and look around your extruder for filament around the gears, make sure those aren’t worn either. If your filament is going in at an angle it can start rubbing on the extruder shaving off your filament effecting flow and diameter of the filament.