For those of you running your printers from a Linux PC, what slicer software works for you? I switched from Windows to Kubuntu about 6 weeks ago. Had been using Orca for about 2 years, but the Linux version doesn't fully function for me. The build plate preview and functions are just a blank page. Trying to link a 3d printer causes Orca to crash. From comments online, there are plenty of people with the same issue and no resolution yet, using various Linux distros. So is anyone having luck with a slicer program using Linux, Wayland, and a nvidia graphics card?

Update 07Aug25: so far seen that Orca does not work with the latest versions of Kubuntu (25.04) nor Ubuntu (25.04). That's trying both flatpack and app image. Installed Mint Cinnamon 22.1 (based off Ubuntu 24.04), and Orca partly runs from a flatpack install. The build plate image and features do show up rather than a blank page, which is a start. Unfortunately trying to link my printer by IP address causes the software to crash after I click on the Device tab. Now Orca won't reopen without immediately freezing up, then crashing after about 20 seconds. I think I read about a workaround on Discord for this, need to find that discussion. Downloaded Prusa, just need to try that as well when I can get back to this. Cura refuses to connect to my printer at all so far. It's been revamped to align with Ultimaker printers, changed a lot from when I used it a couple years ago. I don't think it likes my Klipper setup. May work if I went back to stock Creality firmware, but I have no desire to do that.