2
submitted 1 year ago* (last edited 1 year ago) by madejackson@lemmy.world to c/fixmyprint@lemmy.world

We need to start to fill up lemmy :) Can you solve this issue?

My HEVO (Hypercube Evolution), now 5 years old started to have very weird banding.

It has a Bowden BMG Extruder and a E3D V6 printhead with CHT-Nozzle. MKS Robin with TMC2209 and Klipper.

Benchy is ABS, lower one is HIPS. Printed at 230°/105° bed. part cooling fan off.

I took apart and cleaned the extruder. The gears look intact and i can move the extruder by hand without binding. I found the E3D V6 was loose. I retightened it, which didn't solve the issue.

I'll spend a beer to the one that solves this issue ;)

Edit: Found the Issue: hotend not hot enough.

you are viewing a single comment's thread
view the rest of the comments
[-] LazaroFilm@lemmy.world 2 points 1 year ago

Heyyyy HEVO brother!!!

Have you dried your filament? Also make sure the X rods don’t bend around or the nozzle/carriage isn’t loose.

[-] madejackson@lemmy.world 1 points 1 year ago* (last edited 1 year ago)

Heyouu :) Nice! Showcase your printer? Here's mine.

Yeah my filament is stored in dryboxes and I janked the carriage around, it's fairly stable, no unusual flex :(.

I'm going to make my newly built DuelingZero ready for printing tonight then I can finally fix my HEVO :) I plan on Upgrading to the Hextrudort, which will hopefully fix my issues. Upgrade path ist step by step to a complete hevORT :) let's see how that goes.

[-] LazaroFilm@lemmy.world 2 points 1 year ago* (last edited 1 year ago)

I présent to you Bumblebee!

Bumblebee

I use this carriage and the rail x gantry from the same designer.

this post was submitted on 26 Jul 2023
2 points (100.0% liked)

fixmyprint

92 readers
1 users here now

The community of c/FixMyPrint will help you fix your 3D printer settings for the most optimal prints.

founded 1 year ago
MODERATORS