51
What Exactly is the Issue with my Bambu P1S...? It Both Under and Overextrudes in Batched areas and sometimes leaves what looks like Overheated/Melted Ripples?
(lemmy.blahaj.zone)
I really don't know whats happening. Especially with the Over and Underextruding... Heck the Bottom Left pic shows both happening basically right next to eachother... whats going on?
(The Printed Model in the pic is just the Entire First layer and buildplate printed in. Letting it Run a Third time now to see if the Patterns stay the same)
@Mr_Mofu I don't see the evidence of over-extrusion there. It may be the case that your nozzle is fractionally too close to the build plate, which will often cause ripples (or in extreme cases, gaps) as it pushes filament aside, and may be pushing already-printed areas off the bed. You may also get blobs as material scraped up is redeposited, which in turn can push more printed filament off the bed.