1419
Cyan Low, Rule (slrpnk.net)
submitted 1 year ago by Track_Shovel@slrpnk.net to c/196
you are viewing a single comment's thread
view the rest of the comments
[-] bitsplease@lemmy.ml 15 points 1 year ago

Totally doable, use a multicolor printer and print it like 3 layers thick - you'll get thin flexible plastic sheets.

Not actually practical, but totally doable lol

[-] BigDanishGuy@sh.itjust.works 3 points 1 year ago* (last edited 1 year ago)

Just do a midprint filament swap... Looking at getting into TPU at the moment, it might actually be a fun way to have my kid hand something short in. 3 layers of white, 0.12mm per layer, swap to black and print 3 layers more. I'd be concerned about stringing and delamination. But it's pretty close to the heated bed, so mostly stringing. Fuckit we're going to try!

[-] JusticeForPorygon@lemmy.sdf.org 2 points 1 year ago

Your now going to do this and report back right?

[-] BigDanishGuy@sh.itjust.works 1 points 1 year ago

Actually, I was going to yesterday. But I will try to get to it this weekend. Am becoming a bit worried about warping though...

[-] JusticeForPorygon@lemmy.sdf.org 1 points 1 year ago

Engineering Method my friend

this post was submitted on 01 Nov 2023
1419 points (100.0% liked)

196

16724 readers
2173 users here now

Be sure to follow the rule before you head out.

Rule: You must post before you leave.

^other^ ^rules^

founded 2 years ago
MODERATORS