7
replacement for male connector (beehaw.org)
submitted 2 years ago by afunkysongaday@beehaw.org to c/askelectronics@discuss.tchncs.de
9 comments fedilink hide all child comments

Looking to replace the male connector in this picture. Any idea what it is called and where I can get it? I'm in Germany.

you are viewing a single comment's thread
view the rest of the comments
[-] ottk3@discuss.tchncs.de 2 points 2 years ago* (last edited 2 years ago)

As far as I know are the "PHR" series connectors a variant of the "PH" connectors. They also have a 2.0 mm pitch, but they differ slightly in their housing design. The primary difference in the "PHR" connectors is the presence of a latching feature on the housing. This latch helps to secure the connector halves together, providing additional stability and preventing accidental disconnections.

Check out this page: Common JST Connector Types – Matt's Tech Pages

farnell.com | PHR-5 Technisches Datenblatt

[-] afunkysongaday@beehaw.org 1 points 2 years ago

I ordered some of these:

With a little bit of luck it should be an easy repair. Thanks again!

this post was submitted on 23 Jun 2023
7 points (100.0% liked)

Ask Electronics

3762 readers
1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 2 years ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de