544
Anti Facial Recognition DIY
(lemmy.ml)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 28 Oct 2025
544 points (100.0% liked)
Funny
12226 readers
931 users here now
General rules:
- Be kind.
- All posts must make an attempt to be funny.
- Obey the general sh.itjust.works instance rules.
- No politics or political figures. There are plenty of other politics communities to choose from.
- Don't post anything grotesque or potentially illegal. Examples include pornography, gore, animal cruelty, inappropriate jokes involving kids, etc.
Exceptions may be made at the discretion of the mods.
founded 2 years ago
MODERATORS
Bottom of the mask is the part cut out in the top right picture. It comes from the slope on the top back part of the monitor.
No the top right is clearly one of the face pieces, you can even see where half the eyehole is cut. It also has a large portion without the little holes in it just like the face pieces.
You're right, I clearly didn't look at it close enough.
However, I think I am correct for the source of the material. Now that I look closer I'm pretty sure that the top right picture is actually of the monitor turned on its side. And then he would have taken the matching cut from the other side of the monitor for the other side of the mask.