27
Wifi to ethernet (lemmy.world)
submitted 10 months ago by Dav@lemmy.world to c/networking@sh.itjust.works

Hi all, looking for some guidance on getting wired networking upstairs to my pcs.

Currently I have my internet connection coming in downstairs. Without running cables upstairs is it possible to connect something to my existing wifi network and then break it out to to ethernet?

Any help much appreciated.

you are viewing a single comment's thread
view the rest of the comments
[-] vk6flab@lemmy.radio 16 points 10 months ago

Ethernet over Power, not to be confused with Power over Ethernet, which are NOT the same thing.

[-] HairyHarry@lemmy.world 8 points 10 months ago

I never had a satisfying experience with EOP but I finally discovered Ethernet over Coax. Since I installed them: reliable fast connections and no downtimes.

If you have coax plugs in the needed rooms, try that instead. (I went with bridges from Giga copper).

[-] Limonene@lemmy.world 6 points 10 months ago

I have tried 3 brands of Ethernet over powerline, from 2013 through 2019, and they all broke down after about a year of continuous use. They start at 100Mb/s and gradually decreases to 100Kb/s.

[-] Thrawn@lemmy.dbzer0.com 2 points 10 months ago

Make sure it is a high speed rated one and past that good luck. It depends on what kind of wiring setup is hidden in your walls.

Wi-Fi might actually have higher peak speeds but even a repurposed/double duty wire setup like this is just so much more consistent assuming it works in the first place.

I have had good luck with a set I have that are gigabit rated (get about 280mbps in practice) across 4 different places I have lived however I temporarily pulled them so we could test at some friends apartments and one of them just didn't work at all so be aware that could happen and just have to return them.

[-] scottmeme@sh.itjust.works 2 points 10 months ago* (last edited 10 months ago)

In my use case I was unable to use powerline with 2 breaker panels, but MOCA over coaxial does work great.

[-] CamillaTrend@lemmy.world 1 points 1 week ago

At my dad's house, this technology is really slow, I do not recommend

[-] vk6flab@lemmy.radio 1 points 1 week ago

I suspect that there are other things going on there, speeds for this technology are generally fine, but you do need to figure out which sockets to use, since the best performance is when everything is on the same circuit.

Disclaimer: I've used this, installed it a couple of times and troubleshooting aside, it's worked for me.

this post was submitted on 25 Jan 2025
27 points (100.0% liked)

networking

3373 readers
1 users here now

Community for discussing enterprise networks and the ensuing chaos that comes after inheriting or building one.

founded 2 years ago
MODERATORS