I want to access i2p on my vps without a always connected ssh tunnel. to tried to configure the client.config according to this: https://geti2p.net/en/faq "Configuring your console to be available on a Public IP address with a username & password
Open ~/.i2p/clients.config and replace
clientApp.0.args=7657 ::1,127.0.0.1 ./webapps/
with
clientApp.0.args=7657 ::1,127.0.0.1,(System_IP) ./webapps/
where you replace (System_IP) with your system's public IP address
Go to http://localhost:7657/configui and add a console username and password if desired - Adding a username & password is highly recommended to secure your I2P console from tampering, which could lead to de-anonymization.
Go to http://localhost:7657/index and hit "Graceful restart", which restarts the JVM and reloads the client applications
After that fires up, you should now be able to reach your console remotely. Load the router console at http://(System_IP):7657 and you will be prompted for the username and password you specified in step 2 above if your browser supports the authentication popup. NOTE: You can specify 0.0.0.0 in the above configuration. This specifies an interface, not a network or netmask. 0.0.0.0 means "bind to all interfaces", so it can be reachable on 127.0.0.1:7657 as well as any LAN/WAN IP. Be careful when using this option as the console will be available on ALL addresses configured on your system." Is this possible or do i missunderstood something? i want to use yunohost with redirect to redirect fom 127.0.0.1:7657 to my domainexample routersubdomain.mydomain.com. Is this even possible? Setting clientApp.0.args=7657 ::1,127.0.0.1,(System_IP) ./webapps/ wont work for me. I guess its a chain of misstakes i do :S
You can setup the dashboard to be accessible via encrypted lease sets. You just run i2p on your local machine and access the b32 address with the authorization key.