5
Frt or SS for plastikov (forum.guncadindex.com)
submitted 6 days ago by Frankbeans666@forum.guncadindex.com to c/fosscad@lemmy.ml
9 comments fedilink hide all child comments

Does anyone have any info on how to set up frt or SS in the plastikov v4? Thanks

top 9 comments
sorted by: hot top controversial new old
[-] stickygumm_01@forum.guncadindex.com 2 points 5 days ago

The standard AKSS cam rotates on the factory selector which is not used in the plastikov, and other parts of the plastikov frame are in the way. You would need a complete redesign to get an FRT.

You could use a standard AK binary, but you would be stuck with two position. Three position requires a standard FA AK selector.

[-] Frankbeans666@forum.guncadindex.com 1 points 4 days ago

What about a full auto fcg?

[-] stickygumm_01@forum.guncadindex.com 1 points 4 days ago

The plastikov has features which make it look like a FA sear could be made to work but, it won't fit as is. FA also requires a factory FA selector to hold the FA disconnector tail down.

[-] Frankbeans666@forum.guncadindex.com 1 points 4 days ago

Damn I was thinking that there was enough room for the sear but wasn't sure about them safety being an issue or not. Do you think it would be possible to modify the safety on the plastikov? It doesn't seem like it would be too hard to do.

[-] stickygumm_01@forum.guncadindex.com 1 points 4 days ago* (last edited 3 days ago)

There's a hole close to where the sear goes but it's not in the exact location.

Wouldn't be too hard to mod the selector for three position binary, but getting a FRT work will take a lot of time on both the frame and the trigger housing.

[-] TheShittinator@forum.guncadindex.com 2 points 5 days ago

There's the SSAK but I'm not certain about compatibility or reliability: https://guncadindex.com/detail/SSAK-V1-Beta-V16:e

[-] Frankbeans666@forum.guncadindex.com 1 points 5 days ago

Thanks. I've been trying to find anything about compatibility with binary, frt and SS for the plastikov v4 but can't really find anything. I'm thinking about just getting a 80% receiver after I do the plastikov but any info that anyone had would be awesome.

this post was submitted on 28 Nov 2025
5 points (100.0% liked)

FOSSCAD

398 readers
1 users here now

A community dedicated to the discussion of 3D printed guns and related topics.

Lemmy

founded 3 years ago
MODERATORS
sado@lemmy.ml