annealing PA612CF (forum.guncadindex.com)

submitted 1 day ago by Therustynut@forum.guncadindex.com to c/help@forum.guncadindex.com

5 comments fedilink hide all child comments

I have a hoffman sl9 running in the bambu as I type. Whats some preferred tips and tricks for annealing. Ive heard the obvious temp and time. Do I leave the supports on while its cooking? thanks.

oh yeah, FUCK Reddit.

you are viewing a single comment's thread
view the rest of the comments

[-] Therustynut@forum.guncadindex.com 1 points 1 day ago* (last edited 1 day ago)

flower salt not sure of what that is,? I was going too anneal in the air firer, same one for drying PA.

Edit, is there a need too add moisture into the print afterwards? Im still a bit new to PACF

ok, did some reading. so can i get away with a dish of regular table salt. then 100c for a whopping 16 hrs? damn.

this post was submitted on 05 Dec 2025

7 points (100.0% liked)

Help & Support

183 readers

18 users here now

Post here if you have general questions concerning GunCAD, printing, or otherwise fabricating DIY firearms. Newbies are welcome, but users are encouraged to read Ctrl+PEW's Getting Started Guide if they haven't already.

Shitty stock image may be changed at moderator discretion.

founded 2 months ago

MODERATORS

TheShittinator@forum.guncadindex.com

ItsBildo@forum.guncadindex.com

Alyosha@forum.guncadindex.com